All common block materials up to 40 mm length and even abutments

• composites
• plastics/wax
• glass ceramics
• zirconia
• titanium

Maximum freedom of indication

• crown/bridge
• inlay/onlay
• abutment
• veneer

Groundbreaking

The digital workflow makes it happen: you and your patients can benefit from more pleasant treatments with first-class restorations in just one session. The Z4 is an investment that will pay off for you: high-quality restorations with maximum independence. The number of machinable block materials constantly increases as well as the number of scanners and CAD software packages that are validated with the Z4.

From the intraoral scanner to the milling machine, users work with a single interface and therefore only need to familiarize themselves with one software package. This is the convenience of completely integrated workflows!

The new standard in quality

When it comes to wet machining blocks, the Z4 sets unprecedented quality standards. Fabricate glass-ceramic, PMMA, zirconia and composite restorations in mere minutes and finish highly accurate prefabricated titanium abutments.

Efficiency that is second to none

No external compressed air supply necessary. Only requires clean water. The block is clamped in two seconds. With the Z4, you can work with unparalleled efficiency.

Z4 drills screw-access channels in highest quality

A scientific study at the University of Washington proved that using the Z4, users can drill screw-access channels for hybrid implant restorations into ceramic blocks with no significant difference in flexural strength compared to factory-fabricated materials, known as “meso” blocks.

These blocks are significantly more expensive, and the laboratory design method requires a more sophisticated CAD process. Thus, processing standard blocks with the Z4 means less cost for material and less material inventory necessary.